Setting the IP address for the CobraNet network

For typical audio transport, it is not necessary to specify an IP address for the CobraNet network. However, if you are intending to use SNMP, an IP address and mask are required. The networking settings can be assigned automatically, using DHCP, or manually.

To set the IP address for the CobraNet network

1. From the main menu, select CONFIG to display the first configuration page, LAN CONFIG, then select NEXT repeatedly until the CM-1 NETWORK CONFIG page is displayed.
2. For DHCP operation, use the wheel and the wheel push button to set the IP address to 0 0 0 0 and the mask to 255 255 255 0.

   The settings will be assigned by CobraNet Discovery (DISCO).

   For fixed IP operation, use the wheel and the wheel push button to set the IP address and mask as required by your network.

   

3. Select NEXT to advance to the next page, or OK to confirm the settings and exit.

   To abort the process, select CANCEL.