Troubleshooting

Problem

Meaning

Deployment fails.

Error: Exception Assigning Role: Timeout During Connect. Completed = No

NWare could not establish a reliable network connection to the remote node. A robust connection is required for deployment.

Notes:

• This problem can occur even if the target node is listed on the Remote Log tab and you can PING the node from a Command Prompt window.
• Using a crossover cable between the NWare PC and the remote node can cause this problem. We recommend that you connect the NWare PC and the node to a switch.
• Using a wireless connection can also cause this problem. Switch to using network cables where possible.

Deployment fails.

Role start failed: adapter not initialized

You are attempting to deploy a project containing a CAB to an nControl node or nTouch 180 node, but no network interface has been specified for connecting to the CAB. Connect to the nControl or nTouch 180 via the web interface. Open the Network page. Specify a network interface in the CAB Control Interface list, then reboot the unit.

For more information, see Interfacing with a CAB device in the nControl Hardware Manual or Interfacing with a CAB device in the nTouch 180 Hardware Manual.

The Remote Log tab does not list the node I want to deploy to.

Pandad, the program which locates nodes on the network, may have crashed.

For more information, see Determining if Pandad has stopped functioning in the Pandad Administrator Guide.