Using the web interface

Starting the web interface

The procedure below assumes that you are going to start the nTouch 180 web interface from within NWare, which locates and lists all nTouch 180 units and other MediaMatrix devices, automatically. However, if you know the IP address of the unit, you can type it directly into the location field of your browser, and you will be connected.

To start the web interface

1. Start NWare.
2. At the bottom of the window, click the Remote Log tab.

   A list of devices on the local network will be displayed.

   Tips:

   • If the Remote Log tab is not visible, on the View menu, click Show Output frame.
   • If no devices are listed, Pandad may not be running. Refer to Troubleshooting in Pandad Administrator Guide for more information.

3. Right-click the nTouch 180 unit, and then click Launch Web Interface.

   If the connection is successful, the following screen is displayed.