Installation steps

1. Ensure power to the unit is switched off or the PoE network cable is removed.
2. Attach the metal mounting plate to the NEMA wall box using the appropriate screws (not supplied).

   

3. If the control knob is fitted to the front of the nTouch 60 unit, remove it using the supplied tools.

   

   

4. Plug the Ethernet cable into the RJ-45 socket at the rear of the nTouch 60 unit.

   

5. If you are using a separate power supply cable and not a PoE cable:
   1. Wire a two pin terminal plug so that when the plug is inserted into the two pin header, the power and ground wires correspond to the picture below.

      

   2. Insert the plug into the connector socket.

      

6. Fix the nTouch 60 front panel to the mounting plate using the supplied screws.

   

7. Fit the control knob.