Setting up the NWare SNMP project

Up to 255 NWare controls can be accessed in a project using SNMP. You need to manually specify the number of controls you want to access. You can optionally assign them labels. Each control is then exported as an OID.

To set up the NWare SNMP project

1. Expand the Hardware folder in the device tree, then drag a NioNode over to the design page.
2. In the Number of SNMP exported controls box on the device properties, specify the number of controls (knobs, faders, LEDs etc.) you would like to access using SNMP.
3. Click OK.

   An SNMP Exports tab will now be available on the NioNode control surface. This allows you to toggle controls between read-only and read/write and specify labels that will be available in your SNMP program.

   

   SNMP flyoffs will be added to the Flyoffs tab. You can wire NWare controls to the flyoffs so the control values are automatically passed to the SNMP program, and the SNMP program can send values back to the controls.