GPIO overview

NION and CAB products include a versatile GPIO (General Purpose Input Output) system at the rear for terminating external logic, controls, relays and other external systems. Each control pin is supported by NWare for configuration, control and monitoring. Any combination of control pins may be used simultaneously, regardless of the configuration.

Caution: The pin assignments for the GPIO ports on the NION and CAB devices are not the same. Please be sure to check the documentation carefully when connecting devices to the ports.

In this section

Configurable general purpose ports (8 control pins)

NC and NO relays (4 sets)

Fault relay

Connection

GPIO pin assignment

GPIO connector pin-out table

See also

Technical specifications

Gain structure

Technical Support

Configurable general purpose ports (8 control pins)

These ports represent the bulk of the GPIO functionality. Each of these ports can be configured as follows:

Digital Output

3.0V TTL logic - Low: 0VDC - 0.4VDC;
High: 2.4VDC - 3.3VDC

Digital Input

3.0V TTL logic - Low: 0VDC - 0.8VDC;
High: 2.0VDC - 24VDC

Analog Input

Using external, regulated 24VDC supply.

Rotary encoder

Requires 2 pins and a common.

NC and NO relays (4 sets)

Four Form C relays are available for general purpose usage. These are user configurable from within NWare.

Fault relay

A hardware fault indicator that shows that the CAB is working correctly, or that an internal fault has occurred.