xControl LCD rear

EIA-485 termination switch

This switch has two functions:

• When set to IN, it switches on the termination load for the last xControl LCD in a chain (or a single unit).
• When set to OUT, it specifies that the device will be daisy chained and will not be the last device in the chain, or that bi-directional control will be used. Normally, an xControl LCD is used to control devices in an NWare project, but the unit also supports bi-directional control, where the NWare xControl LCD device can be used to control the physical xControl LCD device.

RJ-45 ports

Standard RJ-45 ports that accept shielded CAT5 or CAT6 data cables. The ports can supply power as well as data.

Each port can be connected to a NION RS-485 port, or another xControl LCD in a daisy-chain configuration.

Mode selector switch

Rotary switch for selecting PASHA mode, resetting the unit and performing tests.

For more information, see Installation steps.

Screw hole

There are four screw holes for fixing the xControl LCD to a wall box.