Updating the firmware

You can update the firmware on the VSC-101 and VSC-101tn products using a flash disk inserted into the USB port at the rear. MediaMatrix Technical Support will provide you with the files you need to install on the flash disk and explain the procedure.

Tip: You can perform a firmware upgrade using buttons on the front panel and remote control, or via an RS-232 connection.

To update the firmware

1. Copy the new firmware file MT23ATV.bin to a USB flash disk.
2. Plug the USB flash disk into the USB port.
3. Press and hold the HDMI button on the front panel for 6 seconds to start the firmware update procedure.

   If you are using an RS-232 connection, send the command 0698%.

4. On the remote control, press OK to confirm the update.

   If you are using an RS-232 connection, send the command 0609%.

5. After the update has finished, reboot the device to restore the factory default settings.

   If you are using an RS-232 connection, send the command 0617%.

6. Reboot the device again.

   If you are using an RS-232 connection, send the command 0617%.