Allowing RATC to be used on a MediaMatrix node

  1. Right-click the NioNode, nControl node or nTouch 180 node, and then click Device Properties.
  2. If you are using a serial connection, click RATC1 or RATC2 in the RS-232 Protocol (COM port) list.

    If you are using a TCP/IP connection, click RATC1 or RATC2 in the Network Control Protocol list.

  3. Deploy the project, and then specify settings on the Serial RATC or Net Ctl tab to match your control system. For example:

See also

Introduction

Commands and Responses

Change groups

RATC1 commands

RATC1 responses