|
|
|
Meter LED displays (numbered 1-4 and 5-8) |
Meaning |
Top line flashing |
The unit is in boot loader mode but has no programme code to run. |
All LEDs flashing on and off |
The unit is in boot loader mode and has programme code which it can run. |
LEDs changing in time to audio |
Normal display mode for the unit. Each numbered column of LEDs represents the dB level of the corresponding channel. |
LED column moving left to right |
No NION is controlling this CAB. |
LED row moving bottom to top |
The unit is in test mode. This display is shown when the CAB is starting up. |
Arrows moving left to right across LED bar |
The unit is in standby mode. It has been connected to another CAB via the Fault connector at the rear of the unit. When a unit is a slave in a master/slave configuration, this display is shown continuously. If a master unit fails, but is then subsequently available, this display will be shown momentarily before the master assumes control from the slave unit. |
No LEDs lit |
The unit is powered and connected to the CobraNet network, it has been assigned a hardware ID from NWare and is now being controlled by a NION. No audio is passing through the unit. |
|
See also |