Slot x: 8ml II

Peak Digital Input Meters

Peak digital input level in dB (23 dB equals full-scale digital input).

Analog Clip

Lit (red) when the input signal is clipped. This occurs when the signal level exceeds the maximum analog sine input level plus 3dB.

Phantom Power

Enables the phantom power feature which supplies power to a microphone via the audio cables attached to the device. This feature is used for condenser microphones.

Note: Check the power requirements of microphones, before connecting them to the NION.

Maximum Analog Sine Input Level

The maximum expected analog RMS input level for the channel. The peak level is 3dB higher.

This control scales the analog input section before the signal is passed to the analog to digital converter. Use it to adjust the sensitivity of the input stage so that the meter display moves across its full range and not just in a small area.

The range is dependent on the type of card you are using.

Mute

Mutes the channel.

Invert

Inverts the polarity of the signal.

Solo. Specifies that the channel is to remain open while all others are muted. Any other channel with Solo on will also remain open.

Digital Gain

The level of gain to be applied to digital signal inside the unit. The signal has already been converted from analog to digital by the A/D converter.

The range is to -100dB to 18dB.

See also

Slot x: 4x4

Slot x: 8i

Slot x: 8ml

Slot x: 8o

Slot x: 8o w/d (with dither)

Slot x: AES

Slot x: AEC

CM-1

GPIO

Monitor

Net Ctl <protocol>

Serial <protocol>

Mute

SNMP Exports