1 Topic by weidong

  • weidong
  • weidong
  • Member
  • Offline
  • Registered: 2007-12-09
  • Posts: 12

Topic: TX and RX error

What will cause Nion node TX and RX error in NWare interface?

For some reasons, I found sometimes TX and RX LED flash, at that moment CobraNet audio will be spasmodically. What canI do now?


Thanks!!!

love peace and music
Tibet is one part of China!!!

2 Reply by Joe Kurta

  • Joe Kurta
  • Member
  • Offline
  • Registered: 2007-08-17
  • Posts: 1,179

Re: TX and RX error

Weidong,

Have you tried using CobraNet Discovery (Disco) to look at the error codes in the CM-1?  If there is a network issue, this may help you figure it out.

Thanks,

Joe

3 Reply by weidong

  • weidong
  • weidong
  • Member
  • Offline
  • Registered: 2007-12-09
  • Posts: 12

Re: TX and RX error

Thanks Joe, I used CobraNet Discovery and I found error code in the CobraNet module, Ivor pasted those error codes in this forum, let me show you.

2091- Buffer exhausted. Network is too busy for the device to transmit its data.
3997696 - Rx quiet. Dropped packets
61 - Same as 3997696
2228226 - beat packet flood
4130,4136 - Flash Failure

love peace and music
Tibet is one part of China!!!

4 Reply by jvalenzuela

  • jvalenzuela
  • Initech programmer
  • Offline
  • From: Orlando, FL
  • Registered: 2007-10-10
  • Posts: 223

Re: TX and RX error

Anything else, non-Cobranet stuff, on this network?

5 Reply by weidong

  • weidong
  • weidong
  • Member
  • Offline
  • Registered: 2007-12-09
  • Posts: 12

Re: TX and RX error

Only CobraNet units, without other non-CobraNet stuff.

love peace and music
Tibet is one part of China!!!