1 Topic by jo

  • jo
  • Member
  • Offline
  • Registered: 2014-01-29
  • Posts: 2

Topic: control cki nxcobranet with nware 1.7.0

hello,
i need help, i have a old system with crest cki and nxcobranet cards (firmware 1.3.67), and is to control with n6, i have nware 1.7.0. i can't see the amplifiers in my software.

thanks
best regards

2 Reply by Rachael

  • Rachael
  • Chief Engineer
  • Offline
  • From: Peavey Oxford
  • Registered: 2008-04-03
  • Posts: 18

Re: control cki nxcobranet with nware 1.7.0

Hi Jo,

I believe this may be an issue which has already been identified and fixed and we have released this fix in NWare 1.7.0a. I've just checked and it appears to not be on the PCA website for download yet. I will follow up with the folks in charge of getting it there to make sure it's put up as soon as possible.

Best Regards,

Rachael

Rachael's Website

3 Reply by jo

  • jo
  • Member
  • Offline
  • Registered: 2014-01-29
  • Posts: 2

Re: control cki nxcobranet with nware 1.7.0

ok, thanks, it's importante to get this asap.

best regards
José oliveira

Last edited by jo (2014-01-29 15:13:33)

4 Reply by JoshM

  • JoshM
  • JoshM
  • Recording Engineer at Burnt Orange Studio
  • Offline
  • From: Meridian, MS
  • Registered: 2007-08-13
  • Posts: 1,498

Re: control cki nxcobranet with nware 1.7.0

jo wrote:

ok, thanks, it's importante to get this asap.

best regards
José oliveira

Hi José,

Please send me an email, I can make sure you get NWare 1.7.0a immediately.

Thanks!

Josh Millward
Burnt Orange Studios

JoshM's Website