1 Topic by fsetterberg

  • fsetterberg
  • Member
  • Offline
  • Registered: 2013-10-01
  • Posts: 2

Topic: Level trim for X-control

Hello all!
I am looking for a level trim for an X-control. Just to clarify what I want:
I have an engineer who sets the proper level in a particular zone. Then I want the "regular" staff to be able to trim the level in the zone for example +/-3dB. I have looked for a solution but have come to the conclusion that I need a script, am I correct?

Thanks!

regards
Fredrik Setterberg
Soliflex Svenska AB
http://www.soliflex.se

2 Reply by Fergy

  • Fergy
  • MM Tech Support
  • Offline
  • From: The Home Office--Meridian
  • Registered: 2007-08-15
  • Posts: 334

Re: Level trim for X-control

Hello Fredrix,

Nope....
Take a look at this topic in the Knowledge Center;

http://peaveyoxford.com/kc/index.htm#12600

And now look at the attached.

Fergy

(So it looked like it was attached...Now it actually is attached)

Post's attachments

Attachment icon Range Limiting Explanation.npa 167.16 kb, 778 downloads since 2013-10-01 

Make it intuitive, never leave them guessing.

3 Reply by fsetterberg

  • fsetterberg
  • Member
  • Offline
  • Registered: 2013-10-01
  • Posts: 2

Re: Level trim for X-control

Hi Fergy and thanks for your quick answer. What I am after though is a way to, whatever the position of the fader, the X-control user shall be able to only adjust it +/-3dB for example.
So if the fader is on 5dB, the range shall be between 2 and 8 dB, if the fader is on 10dB, the range shall be 7-13 and so on.