1 Topic by phils

  • phils
  • Member
  • Offline
  • From: Sydney, Australia
  • Registered: 2007-08-15
  • Posts: 322

Topic: Duplicate Special bug?

I had an embarassment today!
There was an existing signal chain (HPF, LPF, Para, Comp) set up for a paging microphone.
I then used Duplicate Special to make 5 more copies of the whole chain, in one move (smooth, I thought).

Later I got a call that 2 out of the 6 mics weren't passing audio.
After a bit of head-scratching, the guy on site found that 2 of the 5 duplicated HPF had received the settings from the LPF (14kHz - no wonder nothing was getting through). The slope setting was also copied from the LPF to the HPF! It was #3,4 out of the 5 copies. All the other settings are ok.

I tried the Duplicate Special move again, and everything copied correctly.

Anyone seen anything like this??

"The single biggest problem in communication is the illusion that it has taken place."
                                                                                        - George Bernard Shaw