1 Topic by wigl

  • wigl
  • Member
  • Offline
  • Registered: 2007-12-12
  • Posts: 13

Topic: Dante

I tested the Dante cards with 2 Cab 4n and a Nion N3. If I only connect the 2 Cab4n the system works and I can route audio over the Cabs. But if I also connect the the Nion the Cabs loose their Link, on the Front Display of the Cabs I can see the ID and about 10 seconds later the Cabs try to connect again, the Link fails, I can see the ID and so on...
I have the latestest Version of Nware running (1.6.1) and use a Lynksys SRW2008 Gigabit switch.

Anyone with any ideas?

Thanks,
Gerald