1 Topic by phils

  • phils
  • Member
  • Offline
  • From: Sydney, Australia
  • Registered: 2007-08-15
  • Posts: 322

Topic: nTouch180 Command Prompt window

When Kiosk starts, there is a command prompt window in front of the Kiosk screen, but once I click on the kiosk page, it works fine.
I don't know if this is what's refered to in 1.5.3 release notes (my nTouch is 1.5.2), but where do I get MakeUSB for Kiosk 1.5.3a?

"The single biggest problem in communication is the illusion that it has taken place."
                                                                                        - George Bernard Shaw

2 Reply by cwa

  • cwa
  • cwa
  • Peavey Technical Director
  • Offline
  • From: Boulder, Colorado USA
  • Registered: 2007-08-13
  • Posts: 193

Re: nTouch180 Command Prompt window

Phil,
  I've sent you a link to an update.

3 Reply by JoshM

  • JoshM
  • JoshM
  • Recording Engineer at Burnt Orange Studio
  • Offline
  • From: Meridian, MS
  • Registered: 2007-08-13
  • Posts: 1,498

Re: nTouch180 Command Prompt window

In the future, this update will be handled by a firmware update from NWare. We will not be sending out new USB Recovery sticks every time we roll out a new verson of NWare.

Josh Millward
Burnt Orange Studios

JoshM's Website

4 Reply by phils

  • phils
  • Member
  • Offline
  • From: Sydney, Australia
  • Registered: 2007-08-15
  • Posts: 322

Re: nTouch180 Command Prompt window

I was just about to post, and realised I already had (last year):

I have a fresh from Peavey nTouch180. It shows NWare 1.5.3 (is the missing ‘a’ anything to worry about?).
The project is in 1.6.0, but Scott reckons that nothing has changed.

When Kiosk starts (after setting up project page), it finds the project, but then a Command Prompt box (C:\Kiosk\Nware.exe) appears over the top, with many lines of:
“ignoring user_device_guidâ€
“ignoring linking_force_visible=0â€
Once I select the Kiosk screen (visible behind) it’s ok; until next time the panel restarts.
I tried minimizing the box, but it reappears on next restart.

Josh, I've heard that the nice firmware update was postponed.

"The single biggest problem in communication is the illusion that it has taken place."
                                                                                        - George Bernard Shaw