1 Topic by phils

  • phils
  • Member
  • Offline
  • From: Sydney, Australia
  • Registered: 2007-08-15
  • Posts: 322

Topic: Firmware upgrade failed

A dealer was on the end of the phone, and performed a firmware upgrade to 1.5.0 on an n6.
NWare reported "success", but the NioNode did not complete its reboot: it hung at PION STARTING.
Power cycle did not help, nor did a boot into Quiet mode.

Lee in Corby suggested it might be a bad CF.
[new CF image did solve it, but would it be best to replace the CF?]

I have to go to site in the morning to try to sort it - any ideas?
Thanks

Last edited by phils (2009-06-06 09:54:05)

"The single biggest problem in communication is the illusion that it has taken place."
                                                                                        - George Bernard Shaw