|
|
|
Digital Outs |
|
Pin x |
Click to enable digital output on the pin. |
Digital Ins |
|
Pin x |
Lit (green) when digital input is detected on the pin. |
Analog Ins |
|
Value |
Displays a representation of the input voltage level range. The minimum value is represented by zero and the maximum by 1.0. Typically, these inputs are physically connected to a potentiometer. Tip: The knob control cannot be gestured, but you can duplicate it and wire the copy to other controls in your design. This enables you to pass the values to other controls. |
Rotary Encoders |
|
Value |
Displays the input value for a rotary encoder wired to the GPIO port. The value increases when the rotary encoder is moved in one direction and decreased when it is moved in the other. You can also set the value manually by gesturing the knob. |
Relays |
|
1-4 |
Buttons that trigger the internal relays. There are four sets of normally closed (NC) or normally open (NO) relays. For more information, see GPIO overview in the Cab4n Hardware Manual. |
|
See also Slot x: 4 Channel Line Input (black) Slot x: 4 Channel Mic Input (green) |